Ariens Snow Blower 920006 Instrukcja Użytkownika Pobierz pdf (Strona 27)

GB - 27

Check Belt Finger Clearance

(Figure 29)

1. With clutch lever engaged, the belt

finger located opposite the belt idler

must be less than 1/8 in. (3,2 mm) from

belt, but not touching the belt.

To adjust belt finger, loosen the bolts and

move the finger to the proper position.

Tighten the bolts and recheck the belt

finger clearance.

2. Replace the belt cover.

TRACTION DRIVE CLUTCH

ADJUSTMENT

If drive slips, adjust traction clutch to

compensate for friction disc wear.

To test traction clutch (Figure 30):

1. Put unit in first forward speed.

2. Without engine running, push unit

forward while slowly moving the traction

drive clutch lever toward the handlebar.

3. Measure distance between lever and

handlebar when the wheels begin to

brake. If distance is not 7-1/2 – 8 in.

(19.0 – 20.3 cm), adjust the traction

clutch.

To adjust traction clutch (Figure 31):

1. With the traction drive clutch lever

disengaged, loosen the jam nut on the

cable adjuster.

Turn adjustment barrel up the cable to

decrease the distance between clutch

lever and handlebar.

Turn the adjustment barrel down the

cable to increase the distance between

clutch lever and handlebar.

2. Check traction clutch lever distance and

repeat adjustment steps if necessary.

3. Tighten jam nut on traction cable

adjustment barrel.

4. With the clutch disengaged, check that

there is more than 1/32 in. (0.8 mm)

clearance between friction disc and

drive plate assembly. See Figure 32 on

page 28.

Figure 29

OS8067

Check belt finger clearance here. With the

attachment clutch engaged, there should

be less than 1/8 in. (3,2 mm) clearance

between the belt and the belt finger. The

belt finger should not touch the belt.

Traction Clutch Lever

OS2490

Figure 30

7-1/2 – 8 in.

(19.0 – 20.3 cm)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

Komentarze do niniejszej Instrukcji

Brak uwag