Quick Start Guide Deluxe Track 28 (921023 s/n 35000 - 74999) • Step 1: Unfold Handlebar • Step 2: Install Discharge Chute • Step 3: Install Discharge
Fill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK in Owners Manual. Step Nine: Fill Engine Fuel Tank
Step Ten: Starting the Engine
Starting Engine / Step A: Throttle Move the throttle control lever to the fast position. Operate the engine with the throttle control lever in the fas
Starting Engine / Step B: Fuel Valve Turn the fuel shut-off valve to the “ON” position.
Starting Engine / Step C: Key Insert the key and turn to the on/start position.
Starting Engine / Step Four: Choke Turn the choke control knob to the choke position. NOTE: Choke is usually unnecessary when restarting a warm engin
Starting Engine / Step Five: Prime Push the primer two times. NOTE: Priming is usually unnecessary when restarting a warm engine.
Starting Engine / Step 6: (Manual Start) Firmly hold the starter cord handle. Pull the starter cord handle slowly until resistance is felt, then pull
Starting Engine / Step 6: (Electric Start) First connect the extension cord to the power cord receptacle and then into a wall receptacle. I
Starting Engine / Step 7: (Electric Start) Depress the push button. After you start the engine, first disconnect the extension cord from the wall rece
Step One: Unfold Handlebar 1. Remove the lower and loosen the upper hardware on the handlebar assembly. 2. Loosen the hardware on the shift rod. 3. Pu
Starting Engine / Step 8: Warm up Allow the engine to warm up for several minutes. Then, slowly move the choke control knob to the run position.
Step Eleven: Stopping the Engine Turn the key to the off position or move throttle control lever to slow and then to the stop position (completely lef
Additional Resources • Refer to Owners Manual and Engine Manual • Contact Ariens Company www.ariens.com Phone: 920-756-4688 E-mail: [email protected] •
Step Two: Install Discharge Chute 1. Grease underside of discharge chute ring (if not already greased). 2. Remove mounting hardware from auger housing
Step Three: Install Discharge Chute Crank 1. Insert the short end of the chute crank into the hole in the front of the control panel. NOTE: Be carefu
Step Four: Install Remote Deflector Control Cable 1. Connect the cable end to the cable anchor on the discharge deflector before clipping the cable t
Step Five: Check Function of Dual Handle Interlock Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever
Step Six: Check Track Tension Check tracking of unit with the differential locked, and tension of tracks (see Track Tension Adjustment in Owners Manua
Check oil level in auger gearcase (see Check Auger Gearcase in Owners Manual). Step Seven: Check Auger Gearcase Oil
IMPORTANT: The engine is shipped with oil in crankcase. Refer to Engine Manual for detailed instructions. Step Eight: Check Engine Crankcase Oil
Komentarze do niniejszej Instrukcji