Ariens Promaster 144Z Dokumentacja Pobierz pdf (Strona 25)

Left

Blade Side-to-Side Level

Blade Front-to-Back Pitch

Front

Rear Rear

Figure 20

Adjust Blade Height

Level and pitch the mower with the height adjusters on each

deck lift bracket (Figure 21).

Loosen the jam nut on the deck lift bracket bolt about

1/4 turn to reduce clamp load on the height adjusters.

Loosen the jam nut on the deck adjuster bolt and then

turn the bolt clockwise to raise the deck or

counterclockwise to lower the deck. Tighten both jam

nuts.

Height Adjusters

_ ARNING: AVOID INJURY. Read and understand

entire Safety section before proceeding.

SHORT TERM

NEVER spray unit with high pressure water or store unit

outdoors.

Inspect unit for visible signs of wear, breakage or damage.

Keep all nuts, bolts and screws properly tightened and know

unit is in safe working condition.

Store unit in a cool, dry protected area.

LONG TERM

Clean unit thoroughly with mild soap and low pressure water

and lubricate (See LUBRICATE UNITon page 20 in

Maintenance). Touch up all scratched painted surfaces.

Remove weight from wheels by putting blocks under frame

or axle.

When storing unit for extended periods of time, remove all

fuel from tank and carburetor (run dry). Refer to Engine

Manual.

Clean and charge the battery. Charge battery every three to

four weeks when storing unit.

To Take the Unit Out of Storage

1. Refer to the engine service manual to prepare the

engine for service.

2. Put fresh, clean fuel in the fuel tank.

3. Begin the maintenance schedule.

4. Charge and install the battery.

DO NOT place blocks under reinforcement bar.

Figure 21

GB - 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Komentarze do niniejszej Instrukcji

Brak uwag

Ariens Promaster 144Z Dokumentacja Strona 25

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kosiarki Ariens Promaster 144Z